Analysis of the interactions between laser and arc due to different geometric arrangements and laser parameters in the additive manufacturing of Ti-6Al-4V

Additive manufacturing based on arc welding (=DED-Arc) has already established itself in the world of additive manufacturing. Recent process optimizations show the increased use in a hybrid process by irradiating an additional laser beam into the active arc zone. Numerous publications can be found in the literature for steel, aluminum, or bronze, in which, among other things, a strength-enhancing effect or an improved wall surface during this hybrid process is reported. The way in which the laser beam impacts the arc, at what distance, at what angle and with what spot size or focusing appears to be random in the publications and is always chosen differently in the literature. In order to close this knowledge gap, a corresponding holder for a DED-Arc torch and laser optic is developed, which allows these geometric factors to be systematically changed and also enables the titanium alloy Ti-6Al-4V to be processed in a hybrid process. By welding individual tracks and walls with different angles, distances and spot sizes of the two energy sources, a fundamental understanding of the laser-arc hybrid process is created. The results are analyzed using a high-speed camera and evaluated on the basis of surface measurements, micrographs, and power source values. This showed that the distance between the laser and the arc has the greatest effect on the additive process stability and the arc power sources values. In the range of 2–6 mm, there are, in some cases, strong fluctuations in the wire deposition and the arc voltage, so that this range should be avoided. It also showed that a wider spot sizes range of 360–600 μm can be used, whereby different ranges are recommended depending on the target size of uniform wall height or thickness. For the laser incidence angle, the most uniform walls across all tests are achieved at 20°. As the angle of incidence becomes flatter, the walls become more irregular, although there is no linear relationship or areas that should be avoided at all.