FIG. 6.9 BME 280 pressure, humidity and temperature sensor (see: https://shorturl.at/dejkP ). More about this image found in BME 280 pressure, humidity and temperature sensor (see: https://shorturl.a...

FIG. 6.11 BMP180—Atmospheric Pressure Sensor (left picture) (see: https://components101.com/sensors/bmp180-atmospheric-pressure-sensor ) and DS18B20 temperature sensor (right picture) (see: https:// shorturl.at/iqy02 ). More about this image found in BMP180—Atmospheric Pressure Sensor (left picture) (see: https://component...

FIG. 2.16 Effect of the injected pressure on (a) power generation and consumption, and recovery ratio of pressure energy, (b) exergy ratio and system power consumption. More about this image found in Effect of the injected pressure on (a) power generation and consumption, an...

FIG. 4.10 (a) Resistance–pressure phase diagram between M1, M1′, and X phases and (b) experimental temperature–pressure phase diagram ( Chen et al., 2017 ). More about this image found in (a) Resistance–pressure phase diagram between M1, M1′, and X phases and (b)...

FIG. 5.1 Schematic of a MEMS pressure sensor. On the left, we show the top view of the sensor, where we can see the configuration of the four piezoresistors in the Wheatstone bridge circuit. On the right, we show the cross-sectional view of the sensor and the deflection of the sensor diaphragm under an external pressure field ( Sheela et al.) . More about this image found in Schematic of a MEMS pressure sensor. On the left, we show the top view of t...

FIG. 5.2 A schematic of a full Wheatstone bridge circuit with four variable resistors. These resistors represent the piezoresistors mounted on the diaphragm of a MEMS pressure sensor. When the sensor diaphragm remains undeformed, the bridge is balanced, and no signal is detected between points 1 and 3. However, in the presence of an external pressure field, the diaphragm of the sensor deforms, and the resistances of the piezoresistors change. This creates an imbalance in the circuit resulting in a proportional voltage change across the bridge (between points 1 and 3), which is then measured to calculate the pressure changes (Sheela et al.). More about this image found in A schematic of a full Wheatstone bridge circuit with four variable resistor...

FIG. 3.12 Influence of mass flow rate m_IL, a number of theoretical stages N_t (a), absorber temperature T₁ (b), flash drum temperature T₂ (c), and flash drum pressure P₂ (d) on the water content y₁ in the gas product. Reprinted with permission from Yu et al., Energy Fuels 31 (2), 1429–1439 (2017). Copyright 2017 American Chemical Society. More about this image found in Influence of mass flow rate m_IL, a number of th...

FIG. 2.2 Calculated phase diagram of Ga-O system at 1 bar pressure ( Zinkevich and Aldinger, 2004 ). More about this image found in Calculated phase diagram of Ga-O system at 1 bar pressure ( Zinkevich and A...