Equivalent bulk strength of the interface between bonded through the surface activated bonding (SAB) method is found. The interface current was extensively investigated. Nonideal behavior of the junction current is found to be due to the tunneling current between the conduction band and valence band across the transition region associated with band gap states. Interface current decreases with increasing sputtering time and energy and vice versa. Irradiation time and energy dependent behavior indicates that the accumulation of radiation induced defects associated with the doping controls the interface current of Moreover, strong impact of the exposure to an ultrahigh vacuum atmosphere of the activated surfaces on the interface current of is found. Finally it can be suggested that a laser diode can be fabricated by the bonding between and through the SAB method, because of the achievement of equivalent bulk strength of the interface.
Skip Nav Destination
Article navigation
November 2001
This content was originally published in
Journal of Vacuum Science & Technology B: Microelectronics and Nanometer Structures Processing, Measurement, and Phenomena
Research Article|
November 01 2001
Investigation of the bonding strength and interface current of wafers bonded by surface activated bonding at room temperature
M. M. R. Howlader;
M. M. R. Howlader
Research Center for Advanced Science and Technology, University of Tokyo, 4-6-1 Komaba, Meguro-ku, Tokyo 153-8904, Japan
Search for other works by this author on:
T. Watanabe;
T. Watanabe
Research Center for Advanced Science and Technology, University of Tokyo, 4-6-1 Komaba, Meguro-ku, Tokyo 153-8904, Japan
Search for other works by this author on:
T. Suga
T. Suga
Research Center for Advanced Science and Technology, University of Tokyo, 4-6-1 Komaba, Meguro-ku, Tokyo 153-8904, Japan
Search for other works by this author on:
J. Vac. Sci. Technol. B 19, 2114–2118 (2001)
Article history
Received:
June 26 2001
Accepted:
September 04 2001
Citation
M. M. R. Howlader, T. Watanabe, T. Suga; Investigation of the bonding strength and interface current of wafers bonded by surface activated bonding at room temperature. J. Vac. Sci. Technol. B 1 November 2001; 19 (6): 2114–2118. https://doi.org/10.1116/1.1414115
Download citation file:
Pay-Per-View Access
$40.00
Sign In
You could not be signed in. Please check your credentials and make sure you have an active account and try again.
Citing articles via
Future of plasma etching for microelectronics: Challenges and opportunities
Gottlieb S. Oehrlein, Stephan M. Brandstadter, et al.
Transferable GeSn ribbon photodetectors for high-speed short-wave infrared photonic applications
Haochen Zhao, Suho Park, et al.
Filtering the beam from an ionic liquid ion source
Alexander C. G. Storey, Aydin Sabouri, et al.
Related Content
Room temperature bonding of silicon and lithium niobate
Appl. Phys. Lett. (July 2006)
Direct wafer bonding of highly conductive GaSb/GaInAs and GaSb/GaInP heterojunctions prepared by argon-beam surface activation
J. Vac. Sci. Technol. A (April 2016)
Effects of thermal annealing on structural and electrical properties of surface-activated n-GaSb/n-GaInP direct wafer bonds
J. Appl. Phys. (October 2017)
Fast atom beam-activated n-Si/n-GaAs wafer bonding with high interfacial transparency and electrical conductivity
J. Appl. Phys. (May 2013)
Electrical properties of Si/Si interfaces by using surface-activated bonding
J. Appl. Phys. (November 2013)