Appearance potential mass spectrometry (APMS), time-of-flight (TOF) methods, and optical emission spectroscopy (OES) were employed to characterize the active nitrogen species emitted from a 13.56‐MHz radio frequency discharge (RFD) supersonic jet (SSJ) source. OES of the RFD-SSJ plume evidenced only N2 first positive (1+) series bands arising from transitions in addition to He* and Ar* emission lines. APMS yields the relative concentrations of various active nitrogen species (N2+ ions, N2 metastables, and ground-state N atoms) by varying the electron impact ionization energy. TOF sampling was used to discriminate between background and beam signals, and TOF velocity analysis was used to measure the kinetic energies and energy spread of the beam components. By TOF-APMS, we demonstrate that the RFD-SSJ nitrogen source produces primarily ground-state N atoms (4S) with very small concentrations of metastable molecular nitrogen and molecular ions. N2 dissociation fractions of 10%–25% were inferred. Plasma neutral temperatures ranged from 1200 to 1650 K, and energy analysis of TOF velocity data indicated N atom kinetic energies of 0.45–0.49 eV.
Skip Nav Destination
,
,
Article navigation
March 2025
Research Article|
February 05 2025
Time-of-flight appearance potential mass spectrometry of a radio frequency discharge supersonic jet nitrogen source Available to Purchase
Special Collection:
Commemorating the Career of Gerry Lucovsky
Nicholas A. Smith
;
Nicholas A. Smith
(Data curation, Formal analysis, Investigation, Writing – original draft)
Department of Chemical and Biomolecular Engineering, North Carolina State University
, Raleigh, North Carolina 27695-7905
Search for other works by this author on:
Andrew J. Pedersen
;
Andrew J. Pedersen
(Data curation, Formal analysis, Writing – review & editing)
Department of Chemical and Biomolecular Engineering, North Carolina State University
, Raleigh, North Carolina 27695-7905
Search for other works by this author on:
H. Henry Lamb
H. Henry Lamb
a)
(Conceptualization, Funding acquisition, Supervision, Writing – review & editing)
Department of Chemical and Biomolecular Engineering, North Carolina State University
, Raleigh, North Carolina 27695-7905a)Author to whom correspondence should be addressed: [email protected]
Search for other works by this author on:
Nicholas A. Smith
Andrew J. Pedersen
H. Henry Lamb
a)
Department of Chemical and Biomolecular Engineering, North Carolina State University
, Raleigh, North Carolina 27695-7905
a)Author to whom correspondence should be addressed: [email protected]
J. Vac. Sci. Technol. A 43, 023002 (2025)
Article history
Received:
October 30 2024
Accepted:
January 15 2025
Citation
Nicholas A. Smith, Andrew J. Pedersen, H. Henry Lamb; Time-of-flight appearance potential mass spectrometry of a radio frequency discharge supersonic jet nitrogen source. J. Vac. Sci. Technol. A 1 March 2025; 43 (2): 023002. https://doi.org/10.1116/6.0004181
Download citation file:
Pay-Per-View Access
$40.00
Sign In
You could not be signed in. Please check your credentials and make sure you have an active account and try again.
46
Views
Citing articles via
Perspective on improving the quality of surface and material data analysis in the scientific literature with a focus on x-ray photoelectron spectroscopy (XPS)
George H. Major, Joshua W. Pinder, et al.
Low-resistivity molybdenum obtained by atomic layer deposition
Kees van der Zouw, Bernhard Y. van der Wel, et al.
Machine-learning-enabled on-the-fly analysis of RHEED patterns during thin film deposition by molecular beam epitaxy
Tiffany C. Kaspar, Sarah Akers, et al.
Related Content
Surface interactions of SO 2 and passivation chemistry during etching of Si and SiO 2 in SF 6 / O 2 plasmas
J. Vac. Sci. Technol. A (January 2011)
Elucidating energetics and kinetics in environmentally relevant mixed gas plasmas
J. Vac. Sci. Technol. A (July 2021)
Appearance mass spectrometry of neutral radicals in radio frequency plasmas
J. Vac. Sci. Technol. A (July 1992)
Interactions of chlorine plasmas with silicon chloride-coated reactor walls during and after silicon etching
J. Vac. Sci. Technol. A (August 2012)