Snare drums and tom toms used in drum sets often produce an undesirable high frequency ringing sound when struck. Drummers have historically applied DIY damping solutions to address this ringing, placing objects such as wallets and tape on the heads. A large variety of inexpensive commercial products is now available to dampen drums in a more controlled manner. The most commonly used products consist of small adhesive pads that can be placed directly on the drumhead at desired locations, either singly or in combinations. An experimental investigation of the ringing drumhead modes and the effects of the damping pads is reported. Decay rate measurements indicate that the (3,1), (4,1), and (5,1) modes often contribute the most to the ringing sound, and that these modes are strongly affected by the damping pads. Another class of commercial dampener consists of thin annular rings of Mylar that conform to the perimeter of the drum head. These free-floating rings produce a similar damping effect, but dissipate energy through a different physical mechanism. Experimental results for both types of dampeners are presented and discussed in terms of viscoelastic and air-layer damping mechanisms, respectively.
Skip Nav Destination
,
Article navigation
September 2018
Meeting abstract. No PDF available.
September 01 2018
Musical drumhead damping using externally applied commercial products Free
Randy Worland;
Randy Worland
Phys., Univ. of Puget Sound, 1500 N. Warner, Tacoma, WA 98416, [email protected]
Search for other works by this author on:
William Miyahira
William Miyahira
Phys., Univ. of Puget Sound, 1500 N. Warner, Tacoma, WA 98416, [email protected]
Search for other works by this author on:
Randy Worland
William Miyahira
Phys., Univ. of Puget Sound, 1500 N. Warner, Tacoma, WA 98416, [email protected]
J. Acoust. Soc. Am. 144, 1826–1827 (2018)
Connected Content
A companion article has been published:
Physics of musical drum head damping using externally applied products
Citation
Randy Worland, William Miyahira; Musical drumhead damping using externally applied commercial products. J. Acoust. Soc. Am. 1 September 2018; 144 (3_Supplement): 1826–1827. https://doi.org/10.1121/1.5068049
Download citation file:
131
Views
Citing articles via
Focality of sound source placement by higher (ninth) order ambisonics and perceptual effects of spectral reproduction errors
Nima Zargarnezhad, Bruno Mesquita, et al.
A survey of sound source localization with deep learning methods
Pierre-Amaury Grumiaux, Srđan Kitić, et al.
Drawer-like tunable ventilated sound barrier
Yong Ge, Yi-jun Guan, et al.
Related Content
Physics of musical drum head damping using externally applied products
Proc. Mtgs. Acoust. (June 2019)
Normal modes of a musical drumhead under non-uniform tension
J. Acoust. Soc. Am. (January 2010)
Experimental and numerical analysis of the effect of length in musical drumhead coupling
Proc. Mtgs. Acoust. (June 2014)
Experimental and numerical analysis of the effects of depth, diameter, and tension in musical drumhead coupling
J. Acoust. Soc. Am. (November 2013)
Comparison of the Acoustical Performance of Calfskin and Plastic Drumheads
J. Acoust. Soc. Am. (October 1961)