The tangentially viewing visible and vertically viewing infrared camera systems on DIII-D were upgraded to permit emission measurements during edge localized modes (ELMs) with integration times as short as 1 and 100 μs, respectively. The visible system was used to obtain two-dimensional poloidal profiles of CIII (465 nm) and Dα (656.3 nm) emission with 20 μs integration during various stages of ELM events in the lower DIII-D divertor. The infrared system was used to measure the heat flux to the divertor targets at 10 kHz with 100 μs exposure. Upgrades to the data processing and storage systems permitted efficient comparison of the temporal evolution of these measurements.

1.
A. W.
Leonard
et al.,
J. Nucl. Mater.
290–293
,
1097
(
2001
).
2.
H. D. Pacher, “Disruption and ELM Erosion,” App. E9, Sec. 1.7 (Divertor), ITER Design Description Document ITER No. G17 DDD 1 96-08-21 W2.1 August 1996.
3.
M. E.
Fenstermacher
et al.,
Phys. Plasmas
4
,
1761
(
1997
).
4.
D. N.
Hill
et al.,
Rev. Sci. Instrum.
59
,
1225
(
1988
).
5.
M. E.
Fenstermacher
et al.,
Rev. Sci. Instrum.
68
,
974
(
1997
).
6.
D. G.
Nilson
et al.,
Rev. Sci. Instrum.
70
,
738
(
1999
).
7.
http://www.kachinatech.com/∼hjjou/slatec-doc/.
8.
CID Technology Inc. (CIDTEC), 101 Commerce Blvd, Liverpool, NY 13088, http://www.cidetec.com/.
9.
Delft Instruments NV, Röntgenweg 1, 2624 BD, P.O. Box 103, 2600 AC Delft, The Netherlands, http://www.delftinstruments.com/dep/dep.htm
10.
National Instruments Corporation, 11500 N Mopac Expwy, Austin, TX 78759–3504, http://www.ni.com/.
11.
Raytheon—Infrared, 4105 Tami Lane, Central Point, OR 97502, http://www.raytheon.com/
12.
Pacific Advanced Technology, 1000 Edison St., P.O. Box 359, Santa Ynez, CA 93460-0359, http://patinc.com/.
13.
J. T. Hogan et al., Nucl. Mater. (submitted).
This content is only available via PDF.
You do not currently have access to this content.