Skip Nav Destination
Issues
PRELIMINARY
Preface: Proceedings of the International Conference on Mechanical Engineering and Applied Science (ICMEAS 2017)
AIP Conf. Proc. 1919, 010001 (2017)
https://doi.org/10.1063/1.5018518
ARTICLES
Displacement potential solution of a guided deep beam of composite materials under symmetric three-point bending
AIP Conf. Proc. 1919, 020001 (2017)
https://doi.org/10.1063/1.5018519
Comparison of complementary and Kalman filter based data fusion for attitude heading reference system
AIP Conf. Proc. 1919, 020002 (2017)
https://doi.org/10.1063/1.5018520
An experimental model of an indigenous BCI based system to help disabled people to communicate
AIP Conf. Proc. 1919, 020003 (2017)
https://doi.org/10.1063/1.5018521
Simulation of wind flow over square, pentagonal and hexagonal cylinders in a staggered form
AIP Conf. Proc. 1919, 020004 (2017)
https://doi.org/10.1063/1.5018522
Comparative study of aircraft approach and landing performance using ILS, MLS and GLS
AIP Conf. Proc. 1919, 020006 (2017)
https://doi.org/10.1063/1.5018524
Roundness and taper of holes during drilling composites of various thickness by HSS drill bit under dry condition
AIP Conf. Proc. 1919, 020007 (2017)
https://doi.org/10.1063/1.5018525
Structural analysis of a ship on global aspect using ANSYS
AIP Conf. Proc. 1919, 020008 (2017)
https://doi.org/10.1063/1.5018526
Development of a highly maneuverable unmanned underwater vehicle on the basis of quad-copter dynamics
AIP Conf. Proc. 1919, 020009 (2017)
https://doi.org/10.1063/1.5018527
Comparative analysis of emission characteristics and noise test of an I.C. engine using different biodiesel blends
AIP Conf. Proc. 1919, 020010 (2017)
https://doi.org/10.1063/1.5018528
An insight into the maritime accident characteristics in Bangladesh
AIP Conf. Proc. 1919, 020011 (2017)
https://doi.org/10.1063/1.5018529
Finite element analysis of container ship’s cargo hold using ANSYS and POSEIDON software
AIP Conf. Proc. 1919, 020012 (2017)
https://doi.org/10.1063/1.5018530
The augmentation of heat transfer in a pipe flow using a swirling perforated twisted (SPT) tape insert
AIP Conf. Proc. 1919, 020013 (2017)
https://doi.org/10.1063/1.5018531
Global analysis of a renewable micro hydro power generation plant
AIP Conf. Proc. 1919, 020014 (2017)
https://doi.org/10.1063/1.5018532
Modeling and analysis of elastic fields in tibia and fibula
AIP Conf. Proc. 1919, 020016 (2017)
https://doi.org/10.1063/1.5018534
Design of miniature type parallel coupled microstrip hairpin filter in UHF range
AIP Conf. Proc. 1919, 020017 (2017)
https://doi.org/10.1063/1.5018535
Study on the number density of nanobubbles at varying concentration of ethanol in ethanol-water solution
AIP Conf. Proc. 1919, 020018 (2017)
https://doi.org/10.1063/1.5018536
Comparison of performance of shell-and-tube heat exchangers with plain and annular-finned tube bundle
AIP Conf. Proc. 1919, 020019 (2017)
https://doi.org/10.1063/1.5018537
Prospect of solar-PV/biogas/diesel generator hybrid energy system of an off-grid area in Bangladesh
AIP Conf. Proc. 1919, 020020 (2017)
https://doi.org/10.1063/1.5018538
Flat plate solar collector for water pre-heating using concentrated solar power (CSP)
AIP Conf. Proc. 1919, 020021 (2017)
https://doi.org/10.1063/1.5018539
Design, implementation and stabilization of a Bipedal robot
AIP Conf. Proc. 1919, 020023 (2017)
https://doi.org/10.1063/1.5018541
Introduction of Bayesian network in risk analysis of maritime accidents in Bangladesh
AIP Conf. Proc. 1919, 020024 (2017)
https://doi.org/10.1063/1.5018542
Effect of analysis parameters on non-linear implicit finite element analysis of marine corroded steel plate
AIP Conf. Proc. 1919, 020025 (2017)
https://doi.org/10.1063/1.5018543
Propulsive machinery selection for repowering of an old patrol craft – A case study
AIP Conf. Proc. 1919, 020027 (2017)
https://doi.org/10.1063/1.5018545
Effect of phase change material on the heat transfer rate of different building materials
AIP Conf. Proc. 1919, 020029 (2017)
https://doi.org/10.1063/1.5018547
Analysis of thermoelastic characteristics in a thick walled FGM cylinder
AIP Conf. Proc. 1919, 020030 (2017)
https://doi.org/10.1063/1.5018548
Development of an experimental setup for analyzing the influence of Magnus effect on the performance of airfoil
AIP Conf. Proc. 1919, 020032 (2017)
https://doi.org/10.1063/1.5018550
Detail design of empennage of an unmanned aerial vehicle
AIP Conf. Proc. 1919, 020033 (2017)
https://doi.org/10.1063/1.5018551
Property analysis of colloidal quantum dot in semiconductor nanostructure
AIP Conf. Proc. 1919, 020034 (2017)
https://doi.org/10.1063/1.5018552
Potentiality of wind power generation along the Bangladesh coast
AIP Conf. Proc. 1919, 020035 (2017)
https://doi.org/10.1063/1.5018553
Reasons and remedies of inland passenger vessels accidents in Bangladesh
AIP Conf. Proc. 1919, 020036 (2017)
https://doi.org/10.1063/1.5018554
Effect of surface roughness and void fraction on thermal transportation of a solid: A molecular dynamics study
AIP Conf. Proc. 1919, 020037 (2017)
https://doi.org/10.1063/1.5018555
Calm water resistance prediction of a bulk carrier using Reynolds averaged Navier-Stokes based solver
AIP Conf. Proc. 1919, 020038 (2017)
https://doi.org/10.1063/1.5018556
Validation of numerical model for cook stove using Reynolds averaged Navier-Stokes based solver
AIP Conf. Proc. 1919, 020040 (2017)
https://doi.org/10.1063/1.5018558
Determination of coefficient of discharge of nozzle plates at different Reynolds number
AIP Conf. Proc. 1919, 020042 (2017)
https://doi.org/10.1063/1.5018560
Analysis of elastic field in functionally graded material beams with square cross-section
AIP Conf. Proc. 1919, 020044 (2017)
https://doi.org/10.1063/1.5018562
Transitional behaviour of thickness effects in shipbuilding materials (MS plate)
AIP Conf. Proc. 1919, 020045 (2017)
https://doi.org/10.1063/1.5018563
Mixed convection heat transfer simulation in a rectangular channel with a variable speed rotational cylinder
AIP Conf. Proc. 1919, 020048 (2017)
https://doi.org/10.1063/1.5018566
Fabrication of a biomass stove and conversion of electricity from waste heat using TEG
AIP Conf. Proc. 1919, 020050 (2017)
https://doi.org/10.1063/1.5018568
Design of a 100 MW solar power plant on wetland in Bangladesh
Apu Kowsar, Sumon Chandra Debnath, et al.
Inkjet- and flextrail-printing of silicon polymer-based inks for local passivating contacts
Zohreh Kiaee, Andreas Lösel, et al.
Production and characterization of corncob biochar for agricultural use
Praphatsorn Rattanaphaiboon, Nigran Homdoung, et al.