The Vision for Space Exploration has identified the Earth’s moon as a future destination for human explorers as a stepping‐stone for further manned deep space exploration. The feasibility of building and maintaining a human presence on the moon could be directly related to whether in‐situ resources, especially water ice, can be obtained and utilized by astronauts. With the recent success of both Mars Exploration Rovers (MERs), it is clear that a lunar rover could be a desirable platform with which to search for evidence of lunar water prior to the arrival of astronauts. However, since surface water can only exist in permanently shadowed areas of the moon (i.e., deep craters near the poles), conventionally powered rovers would not be practical for exploring these areas for extended periods. Thus, a study was performed to assess the feasibility of a lunar rover mission enabled by small radioisotope power systems (RPS), i.e., systems that use single GPHSs. Small RPSs, the feasibility of which has been looked at by the Department of Energy, would be capable of providing sufficient electrical and thermal power to allow scientific measurements and operations of a small rover on the floor of dark lunar craters. A conceptual study was completed that considered the science instruments that could be accommodated on a MER‐type rover using RPS power. To investigate the subsurface characteristics of the crater floor, a pulsed gamma ray/neutron spectrometer and a ground‐penetrating radar would be used. Also, a drill would provide core samples from a depth of 1 meter. A rover architecture consistent with MER capabilities included a mast with panoramic cameras and navigation cameras as well as an instrument deployment device (IDD) that allowed direct contact between the instrument head and surface materials to be measured. Because the crater floor is eternally dark, artificial illumination must be used for both landing and roving operations. The rover design included of dual headlights that would be operated during visual imaging observations. During the landing approach, the lander would use a laser imaging technique to image the approaching surface and react to that image to avoid hazards. The baseline rover concept used four GPHS power sources for a total of about 50 We in conjunction with a 25 A hr battery to supply power during peak loads. A detailed analysis of energy usage for various operational scenarios (e.g. roving, science instrument operations, and telecommunications) was completed using an elaborate power simulation tool. The results show that very demanding activities are possible on a daily basis while maintaining the battery charging.
Skip Nav Destination
Article navigation
6 February 2005
SPACE TECHNOLOGY AND APPLICATIONS INT.FORUM-STAIF 2005: Conf.Thermophys in Micrograv;Conf Comm/Civil Next Gen.Space Transp; 22nd Symp Space Nucl.Powr Propuls.;Conf.Human/Robotic Techn.Nat'l Vision Space Expl.; 3rd Symp Space Colon.; 2nd Symp.New Frontiers
13-17 February 2005
Albuquerque, New Mexico (USA)
Research Article|
February 06 2005
Searching for Subsurface Lunar Water Ice using a Nuclear‐Powered Rover
James E. Randolph;
James E. Randolph
Jet Propulsion Laboratory — California Institute of Technology, 4800 Oak Grove Drive, Pasadena, CA 91109
Search for other works by this author on:
Robert D. Abelson;
Robert D. Abelson
Jet Propulsion Laboratory — California Institute of Technology, 4800 Oak Grove Drive, Pasadena, CA 91109
Search for other works by this author on:
Knut I. Oxnevad;
Knut I. Oxnevad
Jet Propulsion Laboratory — California Institute of Technology, 4800 Oak Grove Drive, Pasadena, CA 91109
Search for other works by this author on:
James H. Shirley
James H. Shirley
Jet Propulsion Laboratory — California Institute of Technology, 4800 Oak Grove Drive, Pasadena, CA 91109
Search for other works by this author on:
AIP Conf. Proc. 746, 354–366 (2005)
Citation
James E. Randolph, Robert D. Abelson, Knut I. Oxnevad, James H. Shirley; Searching for Subsurface Lunar Water Ice using a Nuclear‐Powered Rover. AIP Conf. Proc. 6 February 2005; 746 (1): 354–366. https://doi.org/10.1063/1.1867151
Download citation file:
Pay-Per-View Access
$40.00
Sign In
You could not be signed in. Please check your credentials and make sure you have an active account and try again.
21
Views
Citing articles via
Inkjet- and flextrail-printing of silicon polymer-based inks for local passivating contacts
Zohreh Kiaee, Andreas Lösel, et al.
Effect of coupling agent type on the self-cleaning and anti-reflective behaviour of advance nanocoating for PV panels application
Taha Tareq Mohammed, Hadia Kadhim Judran, et al.
Design of a 100 MW solar power plant on wetland in Bangladesh
Apu Kowsar, Sumon Chandra Debnath, et al.
Related Content
Concept for a Radioisotope Powered Dual Mode Lunar Rover
AIP Conference Proceedings (January 2006)
Small‐RPS Enabled Mars Rover Concept
AIP Conference Proceedings (February 2005)
Advanced Radioisotope Power System Enabled Titan Rover Concept with Inflatable Wheels
AIP Conference Proceedings (January 2006)
Small Power Technology for Tetrahedral Rovers
AIP Conference Proceedings (January 2006)
Power beaming: Mission enabling for lunar exploration
AIP Conference Proceedings (January 1992)