Acoustic measurement plays important role in aerospace technology for testing and monitoring. Currently, conventional acoustical sensor has been replaced by new type of microphone built with microelectro-mechanical system technology. Although this new type of microphone is smaller in size, its performance is comparable to conventional microphone. However, present standard for the calibration of microphone does not apply to the MEMS microphone because of the difference in the size. In this research, we calibrate the MEMS microphone using multifunction acoustic calibrator. To adapt the size of conventional microphone, a microphone adapter was developed using 3D printer.

1.
R.
Bogue
, “
Recent developments in MEMS sensors: A review of applications, markets and technologies
,”
Sens. Rev.
, vol.
33
, no.
4
, pp.
300
304
,
2013
, doi: .
2.
N.
Tiliakos
,
MEMS for harsh environment sensors in aerospace applications: Selected case studies
.
Woodhead Publishing Limited
,
2013
. doi: .
3.
A.
Katyal
,
M.
Raja
, and
S. K.
Chaturvedi
, “
Application for MEMS in Space
,” vol.
4
, no.
4
, pp.
313
316
,
2014
.
4.
M.
Mansoor
,
I.
Haneef
,
S.
Akhtar
,
M. A.
Rafiq
,
S. Z.
Ali
, and
F.
Udrea
, “
SOI CMOS multi-sensors MEMS chip for aerospace applications
,”
Proc. IEEE Sensors
, vol.
2014
-Decem, no. December, pp.
1204
1207
,
2014
, doi: .
5.
Y.
Javed
,
M.
Mansoor
, and
I. A.
Shah
, “
A review of principles of MEMS pressure sensing with its aerospace applications
,”
Sens. Rev.
, vol.
39
, no.
5
, pp.
652
664
,
2019
, doi: .
6.
M.
Sheplak
,
J. M.
Seiner
,
K. S.
Breuer
, and
M. A.
Schmidt
, “
AIAA 99-0606 A MEMS Microphone for A (Eroacoustics Measurements 37th. AlAA Aerospace Sciences, Meeting and Exhibit, January 11-14, 1999 / Reno, NV a Measurements
,”
Sci. York
, no. c.
7.
X.
Zhang
,
J.
Huang
,
E.
Song
,
H.
Liu
,
B.
Li
, and
X.
Yuan
, “
Design of small MEMS microphone array systems for direction finding of outdoors moving vehicles
,”
Sensors (Switzerland)
, vol.
14
, no.
3
, pp.
4384
4398
,
2014
, doi: .
8.
S.
Shubham
and
M.
Nawaz
, “
Estimating Parasitic Capacitances in MEMS Microphones using Finite Element Modeling
,” no.
1
,
2019
.
9.
H.
Gharaei
and
J.
Koohsorkhi
, “
Design and characterization of high sensitive MEMS capacitive microphone with fungous coupled diaphragm structure
,”
Microsyst. Technol.
, vol.
22
, no.
2
, pp.
401
411
,
2016
, doi: .
10.
I.
Introduction
, “
Boundary Layer Measurements
,”
Design
, no. January, pp.
1
8
,
2012
.
11.
A.
Bale
and
D. A.
Johnson
, “
The application of a MEMS microphone phased array to aeroacoustics of small wind turbines
,”
Wind Eng.
, vol.
37
, no.
6
, pp.
637
657
,
2013
, doi: .
12.
É.
Salze
,
E.
Jondeau
,
A.
Pereira
,
S. L.
Prigent
, and
C.
Bailly
, “
A new mems microphone array for the wavenumber analysis of wall-pressure fluctuations: Application to the modal investigation of a ducted low-mach number stage
,”
25th AIAA/CEAS Aeroacoustics Conf. 2019
, no. May, pp.
1
12
,
2019
, doi: .
13.
International Electrotechnical Commission 61904-5
,”
2016
.
14.
International Electrotechnical Commission 61904-8
,”
2012
.
15.
B. & Kjaer
, “
Datasheet Multifunction Acoustic Calibrator Type 4226
,” pp.
1
4
,
2019
.
This content is only available via PDF.
You do not currently have access to this content.