This research is about implementing data validation with checksum Cyclic Redundancy Check 32 (CRC32) in data transmission between microcontroller Arduino Uno and Android devices with Bluetooth serial communication. The purpose of the project is to reduce the potential of broken data while data transmission and evaluation of time are needed in the system in data validation. The hardware that is used in this project is microcontroller Arduino Uno R3, Bluetooth HC-05, SD Card Module, and Android Device. This system will be tested using data with a variable size of about 10 bytes to 10 MB. The recent Result of this project shows that data validation will reduce the potential of broken data, but the consequences of this method user need to wait longer because the system needs to request data until the system detect true, but between the system with data validation or not, time which is needed by the system to process data from start to end were about from 0 to 1371 ms for each data.
Skip Nav Destination
Article navigation
20 August 2024
INTERNATIONAL CONFERENCE ON GREEN TECHNOLOGY AND DESIGN (ICGTD) 2021: Human Behavior and Its Relevance in Technology and Design Research for Supporting the Recovery of Post-Pandemic Environment
2–3 December 2021
Bandung, Indonesia
Research Article|
August 20 2024
Data transmission system via bluetooth using validation cyclic redundancy check 32 (CRC32) method
Febrian Hadiatna;
Febrian Hadiatna
a)
1
Department of Electrical Engineering, Institut Teknologi Nasional Bandung
, Jalan PHH. Musthopa No.23 Bandung 40123, Indonesia
a)Corresponding author: [email protected]
Search for other works by this author on:
Ratna Susana;
Ratna Susana
b)
1
Department of Electrical Engineering, Institut Teknologi Nasional Bandung
, Jalan PHH. Musthopa No.23 Bandung 40123, Indonesia
Search for other works by this author on:
Banu Sudewa
Banu Sudewa
c)
1
Department of Electrical Engineering, Institut Teknologi Nasional Bandung
, Jalan PHH. Musthopa No.23 Bandung 40123, Indonesia
Search for other works by this author on:
AIP Conf. Proc. 2744, 020006 (2024)
Citation
Febrian Hadiatna, Ratna Susana, Banu Sudewa; Data transmission system via bluetooth using validation cyclic redundancy check 32 (CRC32) method. AIP Conf. Proc. 20 August 2024; 2744 (1): 020006. https://doi.org/10.1063/5.0187430
Download citation file:
Pay-Per-View Access
$40.00
Sign In
You could not be signed in. Please check your credentials and make sure you have an active account and try again.
13
Views
Citing articles via
Inkjet- and flextrail-printing of silicon polymer-based inks for local passivating contacts
Zohreh Kiaee, Andreas Lösel, et al.
Design of a 100 MW solar power plant on wetland in Bangladesh
Apu Kowsar, Sumon Chandra Debnath, et al.
Production and characterization of corncob biochar for agricultural use
Praphatsorn Rattanaphaiboon, Nigran Homdoung, et al.
Related Content
Mobile based Appliances switching using Bluetooth
AIP Conference Proceedings (April 2008)
Design and implementation of bluetooth microcontroller in system-on-chip (SoC)
AIP Conf. Proc. (February 2024)
Utilization of bluetooth wireless for SOFC test rigs with android smartphone device
AIP Conf. Proc. (April 2020)
Sliding gate opener system with smartphone control using bluetooth connection
AIP Conf. Proc. (July 2023)
Note: Methodology for the analysis of Bluetooth gateways in an implemented scatternet
Rev. Sci. Instrum. (March 2014)