Metal plating starts to be widely used as a way to prevent metal corrosion. Apart from preventing corrosion, metal coatings were being developed to thicken the metal, increase its hardness, wear resistance and corrosion resistance. The purpose of this research is to make Ni coating over Al substrate in time variation differences (3.5 h, 4.5 h and 5 h) with a constant current of 50 mA cm-2. The characterization of the materials used was from SEM-EDS, XRD and digital cameras. The SEM characterization results showed a crystal shape similar to a pyramid and contained Ni oxide content in the Ni coating, although in the XRD observations did not appear. The increasing of the coating time will increase the crystal size in the direction of the preferred plane orientation [111] which was confirmed by the calculation of the orientation index. The Ni 5 sample has hydrophobic properties with a contact angle of 91 °.

1.
J.
Sudagar
,
J.
Lian
, and
W.
Sha
, “
Electroless nickel, alloy, composite and nano coatings - A critical review
,”
J. Alloys Compd.
, vol.
571
, pp.
183
204
,
2013
.
2.
A. V.
Logunov
,
D. V.
Danilov
, and
R. V.
Khramin
, “
High-Strength Nickel-Based Alloy SLGS-5 for Operation in Active Marine Salt Corrosion Environment
,”
Mater. Today Proc.
, vol.
11
, pp.
453
458
,
2019
.
3.
N.
Li
,
W.
Li
,
X.
Yang
,
Y.
Xu
, and
A.
Vairis
, “
Corrosion characteristics and wear performance of cold sprayed coatings of reinforced Al deposited onto friction stir welded AA2024-T3 joints
,”
Surf. Coatings Technol.
, vol.
349
, no. April, pp.
1069
1076
,
2018
.
4.
F.
Soleimangoli
,
S. A.
Hosseini
,
A.
Davoodi
,
A.
Mokhtari
, and
M.
Alishahi
, “
Effect of NH4Cl on the microstructure, wettability and corrosion behavior of electrodeposited Ni–Zn coatings with hierarchical nano/microstructure
,”
Surf. Coatings Technol.
, vol.
394
, no. April, p.
125825
,
2020
.
5.
B.
Abedini
,
N. Parvini
Ahmadi
,
S.
Yazdani
, and
L.
Magagnin
, “
Electrodeposition and corrosion behavior of Zn−Ni−Mn alloy coatings deposited from alkaline solution
,”
Trans. Nonferrous Met. Soc. China
(English Ed., vol.
30
, no.
2
, pp.
548
558
,
2020
.
6.
K. S.
Jyotheender
,
A.
Gupta
, and
C.
Srivastava
, “
Grain boundary engineering in Ni-carbon nanotube composite coatings and its effect on the corrosion behaviour of the coatings
,”
Materialia
, vol.
9
, no. October
2019
, p.
100617
, 2020.
7.
B.
Soegijono
,
F. B.
Susetyo
,
H. A.
Notonegoro
, and
M. C.
Fajrah
, “
Electrochemical Behavior, Structure, and Morphology of Electrodeposited Nickel on Copper Alloy Prepared from Sulfate Bath without Additive Addition
,”
FLYWHEEL J. Tek. Mesin Untirta
, vol.
VI
, no.
1
, p.
6
,
2020
.
8.
I.
Kharmachi
,
L.
Dhouibi
,
P.
Berçot
, and
M.
Rezrazi
, “
Pulse plating as an alternative approach to improve Ni-Co alloys properties coated from a bath with a low nickel content
,”
J. Mater. Environ. Sci.
, vol.
7
, no.
5
, pp.
1670
1684
,
2016
.
9.
K.
Mausam
and
M.
Goyal
, “
Development of nanocrystalline Ni-Al coatings and its thermal stability
,”
Mater. Today Proc.
, no.
xxxx
,
2020
.
10.
F. B.
Susetyo
,
M. C.
Fajrah
, and
B.
Soegijono
, “
Effect of electrolyte temperature on properties of nickel film coated onto copper alloy fabricated by electroplating
,”
e-Journal Surf. Sci. Nanotechnol.
, vol.
18
, no.
10
, pp.
223
230
,
2020
.
11.
P. P.
Surabaya
, “
ANALISIS PENGARUH ELECTROPLATING PADA ALUMINIUM ALLOY 2024 MENGGUNAKAN NIKEL DAN KROM TERHADAP LAJU KOROSI
,” no. September, pp.
1
6
,
2018
.
12.
L.
Jinlong
,
L.
Tongxiang
, and
W.
Chen
, “
Effect of electrodeposition temperature on grain orientation and corrosion resistance of nanocrystalline pure nickel
,”
J. Solid State Chem.
, vol.
240
, pp.
109
114
,
2016
.
13.
B.
Li
et al., “
Effect of current density and deposition time on microstructure and corrosion resistance of Ni-W/TiN nanocomposite coating
,”
Ceram. Int.
, vol.
45
, no.
4
, pp.
4870
4879
,
2019
.
14.
H. S.
Maharana
,
B.
Bishoyi
, and
A.
Basu
, “
Current density dependent microstructure and texture evolutionand related effects on properties of electrodeposited Ni-Al coating
,”
J. Alloys Compd.
, vol.
787
, pp.
483
494
,
2019
.
15.
Sutomo
,
Senen
, and
Rahmat
, “Pengaruh arus dan waktu pada pelapisan nikel dengan elektroplating untuk bentuk plat,”
Fak. Tek. Univ. Diponegoro
,
Indones
.
16.
S.
Raharjo
, “
Pengaruh Variasi Tegangan Listrik Dan Waktu Proses Electroplating Terhadap Sifat MekanisDan Struktur Mikro Baja Karbon Rendah Dengan Krom Samsudi
,”
Jurnal. Unimus. Ac. Id
, pp.
296
308
,
2010
.
17.
A. M.
Koten
,
J. U.
Jasron
,
J. T.
Mesin
,
U. N.
Cendana
, and
K.
Mikro
, “
Pengaruh Variasi Tegangan dan Waktu Terhadap Kekerasan Lapisan Nikel dengan Metode Electroplating pada Coran Aluminium scrap
,” vol.
03
, no.
01
,
2016
.
18.
A. F.
Alphanoda
, “
Pengaruh Jarak Anoda-Katoda dan Durasi Pelapisan Terhadap Laju Korosi pada Hasil Electroplating Hard Chrome
,”
J. Teknol. Rekayasa
, vol.
1
, no.
1
, p.
1
,
2017
.
19.
D.
Suwardi
, “
Pengaruh Elektroplating Nikel Dengan Variasi Waktu Pelapisan 30, 60, 90, 120, 150 Menit Terhadap Kekasaran Permukaan, Titik Luluh Kekuatan Tarik Maksimum Baja Karbon
,”
J. Tek. mesin Fak. Tek. Univ.MUHAMMADIYAH SURAKARTA
,
2017
.
20.
M. Y.
Niam
,
H.
Purwanto
, and
S. M. B.
Respati
, “
Pengaruh Waktu Pelapisan Elektro …;
,” vol.
13
, no.
1
, pp.
7
10
,
2017
.
21.
F.
Nasirpouri
et al., “
An investigation on the effect of surface morphology and crystalline texture on corrosion behavior, structural and magnetic properties of electrodeposited nanocrystalline nickel films
,”
Appl. Surf. Sci.
,
2014
.
22.
M.
Abdulwahab
,
O. S. I.
Fayomi
, and
A. P. I.
Popoola
, “
Structural evolution, thermomechanical recrystallization and electrochemical corrosion properties of Ni-Cu-Mg amorphous coating on mild steel fabricated by dual-anode electrolytic processing
,”
Appl. Surf. Sci.
,
2016
.
23.
M. M.
Kamel
,
Z. M.
Anwer
,
I. T.
Abdel-Salam
, and
I. S.
Ibrahim
, “
Nickel electrodeposition from novel lactate bath
,” in
Transactions of the Institute of Metal Finishing
,
2010
.
24.
M. A. M.
Ibrahim
and
R. M.
Al Radadi
, “
Role of glycine as a complexing agent in nickel electrodeposition from acidic sulphate bath
,”
Int. J. Electrochem. Sci.
,
2015
.
25.
C. qun
LI
,
X. hai
LI
,
Z. xin
WANG
, and
H. jun
GUO
, “
Nickel electrodeposition from novel citrate bath
,”
Trans. Nonferrous Met. Soc. China
(English Ed.,
2007
.
26.
Z.
Shafiee
,
M. E.
Bahrololoom
, and
B.
Hashemi
, “
Electrodeposition of nanocrystalline Ni/Ni-Al2O3 nanocomposite modulated multilayer coatings
,”
Mater. Des.
,
2016
.
27.
M. H. M.
Zaki
,
Y.
Mohd
, and
N. N. C.
Isa
, “
The effect of current density on surface properties of electrodeposited copper coatings on modified aluminium
,” in
AIP Conference Proceedings
,
2018
.
28.
A.
Augustin
,
K. U.
Bhat
,
K. R.
Udupa
, and
A. C.
Hegde
, “
Electron microscopic study of nodules formed during electrodeposition of copper on aluminium
,” in
Materials Science Forum
,
2015
.
29.
T.
Zubar
et al., “
The effect of heat treatment on the microstructure and mechanical properties of 2d nanostructured au/nife system
,”
Nanomaterials
, vol.
10
, no.
6
, pp.
1
14
,
2020
.
30.
S.
Spanou
,
E. A.
Pavlatou
, and
N.
Spyrellis
, “
Ni/nano-TiO2 composite electrodeposits: Textural and structural modifications
,”
Electrochim. Acta
, vol.
54
, no.
9
, pp.
2547
2555
,
2009
.
31.
T.
Lampke
,
B.
Wielage
,
D.
Dietrich
, and
A.
Leopold
, “
Details of crystalline growth in co-deposited electroplated nickel films with hard (nano)particles
,”
Appl. Surf. Sci.
, vol.
253
, no.
5
, pp.
2399
2408
,
2006
.
32.
S.
Pathak
et al., “
Influence of lower current densities on the residual stress and structure of thick nickel electrodeposits
,”
Surf. Coatings Technol.
, vol.
205
, no.
12
, pp.
3651
3657
,
2011
.
33.
S. A.
Lajevardi
,
T.
Shahrabi
,
J. A.
Szpunar
,
A. Sabour
Rouhaghdam
, and
S.
Sanjabi
, “
Characterization of the microstructure and texture of functionally graded nickel-Al2O3 nano composite coating produced by pulse deposition
,”
Surf. Coatings Technol.
, vol.
232
, pp.
851
859
,
2013
.
34.
M. B.
Radovanović
and
M. M.
Antonijević
, “
Protection of copper surface in acidic chloride solution by non-toxic thiadiazole derivative
,”
J. Adhes. Sci. Technol.
, vol.
31
, no.
4
, pp.
369
387
,
2017
.
35.
Z. Z.
Tasic
,
M. M.
Antonijevic
,
M. B. Petrovic
Mihajlovic
, and
M. B.
Radovanovic
, “
The influence of synergistic effects of 5-methyl-1H-benzotriazole and potassium sorbate as well as 5-methyl-1H-benzotriazole and gelatin on the copper corrosion in sulphuric acid solution
,”
J. Mol. Liq.
, vol.
219
, pp.
463
473
,
2016
.
36.
R.
SEAKR
, “
Microstructure and crystallographic characteristics of nanocrystalline copper prepared from acetate solutions by electrodeposition technique
,”
Trans. Nonferrous Met. Soc. China
(English Ed., vol.
27
, no.
6
, pp.
1423
1430
,
2017
.
37.
W. D.
Callister
, “
Materials science and engineering: An introduction
(
2nd
edition),”
Mater. Des.
, vol.
12
, no.
1
, p.
59
,
1991
.
38.
C. R.
Thurber
et al., “
Electrodeposition of 70-30 Cu-Ni nanocomposite coatings for enhanced mechanical and corrosion properties
,”
Curr. Appl. Phys.
, vol.
16
, no.
3
, pp.
387
396
,
2016
.
This content is only available via PDF.
You do not currently have access to this content.