The steady state thermodynamic investigation of vapour compression refrigeration system (VCRS) using CNT, Au and HAuCl4 nanoparticles suspended in different proportions in polyalkylene glycol lubricant is carried out and presented in this paper. The most commonly adopted R134a refrigerant is used in the system. The energetic and exergetic analysis are performed for nanoparticles with different volume fractions viz. 0.1% Au, 0.2% Au, 0.1% HAuCl4, 0.2% HAuCl4, 0.1% Au and 0.05% CNT, 0.2% Au and 0.02% of CNT. The experimental test rig is fabricated and tested with the different proportions of nanoparticles. Compressor exit temperature and pressure, condenser exit temperature, evaporator inlet and exit temperature are measured. The energy and exergy efficiency of the system components, cooling capacity, compressor power input and coefficient of performance (COP) of the system are obtained. The suspension of Au, HAuCl4 and CNT nanoparticles up to 0.2% and combination of Au(0.1%, 0.2%) and CNT(0.02%, 0.05%) increases the heat transfer characteristics and thereby system functioning. From the results it is established that the power input decreases by 16.7%, COP increases by 21.3% and the second law efficiency increases by 11.2%.

1.
I.M.
Mahbubal
,
S.A.
Fadhilah
,
R.
Saidur
,
K.Y.
Leong
and
M.A.
Amalina
,
Thermophysical properties and heat transfer performance of Al2O3/R-134a nanorefrigerants
,
International Journal of Heat and Mass Transfer
, Vol.
56
, No.
1
, pp.
100
108
(
2013
).
2.
M.J.
Assael
,
I.N.
Metaxa
,
K.
Kakosimos
and
D.
Constantinou
,
Thermal conductivity of nanofluids- Experimental and theoretical
,
International Journal of Thermophysics
, Vol.
27
, No.
4
, pp.
999
1017
(
2006
).
3.
T.
Kavitha
,
A.
Rajendran
,
A.
Durairajan
and
M.
Syedabuthahir
,
Advanced heat transfer enhancement using TiO2 water based nano fluids
,
International Journal of Mechanical and Industrial Engineering
, Vol.
2
. No.
4
, pp.
2231
6477
, (
2012
).
4.
P.
Keblinst
,
S.R.
Phillpot
,
U.S.
Choi
and
J.A.
Eastman
,
Mechanism of heat flow in suspension nanosized particals (nano fluid
),
International Journal of Heat and Mass Transfer
, Vol.
45
, No.
4
, pp.
855
863
(
2002
).
5.
M.
Hariharan
,
S.
Chandrakanth
and
S.
Sundararaj
,
An Investigation Report on Ejector Refrigeration System
,
International Journal of Applied Engineering Research
, Vol.
10
, No.
3
, pp.
2520
2523
(
2015
).
6.
D. Sendil
Kumar
and
Dr.
Elansezhian
,
Experimental study on Al2O3 –R134a refrigerant in refrigeration system
,
International Journal of Modern Engineering Research
, Vol.
2
, No.
5
, pp.
3927
3929
(
2012
).
7.
R. Reji
Kumar
,
K.
Sridhar
and
M.
Narasimha
,
Heat transfer enhancement in domestic refrigerator using R600a/mineral oil/nano-Al2O3 as working fluid
,
International Journal of Computational Engineering Research
, Vol.
03
, No.
4
, pp.
42
50
. (
2013
).
8.
Kuljeet
Singh
and
Kundanlal
,
An investigation into the performance of a nano-refrigerant(R134a+Al2O3) based refrigeration system
,
International Journal of Research in Mechanical Engineering and Technology
, Vol.
4
, No.
2
, Special –
2
, pp.
158
162
,
2014
.
9.
Tarun
Sharma
and
Kundan Lal
Rana
,
An experimental investigation of nano-refrigerant based refrigeration system
,
International Journal of Electronics, Electrical and Computational System
, Vol.
4
, Special Issue, pp.
317
322
, (
2015
).
10.
Mahesh Suresh
Patil
,
Sung Chul
Kim
and
Moo Yeon
Lee
,
Review of the thermo-physical properties of a refrigeration system
,
Energies
, Vol.
22
, No.
9
, doi: , (
2016
).
11.
Hernandez
,
C.
Diana
,
Nieto-Londono
,
César
Zapata-Benabithe
and
Zulamita
,
Analysis of working nanofluids for a refrigeration system
.
Dyna rev.fac.nac.minas [online].
Vol.
83
, No.
196
, pp.
176
183
. (
2016
).
12.
T.
Coumaressin
and
K.
Palaniradja
,
Performance analysis of a refrigeration system using nano fluid
,
International Journal of Advanced Mechanical Engineering
, Vol.
4
, No.
4
, pp.
459
470
(
2014
).
13.
Majid I.
Abdulwahab
, and
S.M.
Thahab
,
Experimental study of thermophysical properties of TiO2nanofluid
Iraqi Journal of Chemical and Petroleum Engineering
, Vol.
17
, No.
2
, pp.
1
6
(
2016
).
14.
K.S.
Sanvordenker
,
R152a Versus R134a in domestic refrigerator-freezer - energy advantage or energy penalty!, International Refrigeration and Air Conditioning Conference
.
Paper 163.
(
1992
).
15.
Mahesh Suresh
Patil
,
Sung Chul
Kim
, and
Moo Yeon
Lee
,
Review of the thermo-physical properties of a refrigeration system
,
Energies
, Vol.
22
, No.
9
, doi:, (
2016
).
16.
Weiting
Jiang
,
Guoliang
Ding
and
Hao
Peng
,
Measurement and model on thermal conductivities of carbon nanotube nanorefrigerants
,
International Journal of Thermal Sciences
, Vol.
48
, No.
6
, pp.
1108
1115
(
2009
).
17.
J.U.
Ahamed
,
R.
Saidur
and
H.H.
Masjuki
,
A review on exergy analysis of vapor compression refrigeration system
,
Renewable and Sustainable Energy Reviews
, Vol.
15
, pp.
1593
1600
(
2011
).
18.
S.
Sundararaj
,
R. Sasi
kumar
,
Shake
misshal
,
C.
Siddharth
and
V.
Soundar
,
The effect of refrigerant pairs on performance of multi-cycle vapour compression system
,
Advances in Natural and Applied Sciences
, Special
10
(
7
), pp.
112
122
(
2016
).
19.
M.A.
Rosen
,
I.
Dincer
, and
M.
Kanoglu
,
Role of exergy in increasing efficiency and sustainability and reducing environmental impact
,
Energy Policy
, Vol.
36
, pp.
128
137
(
2008
).
20.
Manoj
Dixit
,
S.C.
Kaushik
and
Akhilesh
Arora
,
Energy and exergy analysis of absorption- compression cascade refrigeration system
,
Journal of Thermal Engineering
, Vol.
2
, No.
6
, Special Issue
5
, pp.
995
1006
, (
2016
).
21.
Yunus A.
Cengel
,
Michael A.
Boles
,
Thermodynamics: An Engineering Approach
, Fifth Edition.
22.
E.
Halimic
,
D.
Ross
,
B.
Agnew
,
A.
Anderson
and
I.
Potts
,
A comparison of the operating performance of alternative refrigerants
,
Applied Thermal Engineering
, Vol.
23
, pp.
1441
1451
, (
2003
).
23.
Forane ver 4.0 : Refrigeration Simulator
.
24.
Gulshan
Sachdeva
,
Vaibhav
Jain
,
Comparative exergy analysis of vapor compression refrigeration system using alternative refrigerants
,
International Journal of Mechanical and Mechatronics Engineering
, Vol.
10
, No.
6
, pp.
1081
1088
(
2016
).
This content is only available via PDF.
You do not currently have access to this content.