The existence of electric vehicles is believed to be a solution to solve issues in the transportation sector nowadays. The development of electric vehicles that are rapidly growth is the motive of the author to conduct research in analyzing the use of power consumption in electric car prototype. Research is carried out by focusing on data processing from two fundamental components in electric vehicles, which are the battery and electric motor. The motor used in this car is 2 kW brushless DC (BLDC) motor type and Lead acid battery. A controller will be used in order to regulate the operation of the electric motor. The research was conducted successfully with two methods: operation of electric car without load and with load on the road. In conditions with no load, the average motor power is obtained at 229.7 watts; in conditions with load on the road, the average motor power is obtained at 639.7 watts. The power efficiency obtained during the test gets a percentage value of up to 84.30%
Skip Nav Destination
Article navigation
13 April 2020
THE 5TH INTERNATIONAL CONFERENCE ON INDUSTRIAL, MECHANICAL, ELECTRICAL, AND CHEMICAL ENGINEERING 2019 (ICIMECE 2019)
17–18 September 2019
Surakarta, Indonesia
Research Article|
April 13 2020
Analysis of motor power characterization and power efficiency on operation of electric car prototype
Ferdiansyah Ashil Farisi;
Ferdiansyah Ashil Farisi
1
Department of Electrical Engineering, Faculty of Engineering, Universitas Sebelas Maret
, Surakarta, Indonesia
Search for other works by this author on:
Miftahul Anwar;
Miftahul Anwar
a)
1
Department of Electrical Engineering, Faculty of Engineering, Universitas Sebelas Maret
, Surakarta, Indonesia
a)Corresponding author: miftahwar@ft.uns.ac.id
Search for other works by this author on:
M. Nizam;
M. Nizam
1
Department of Electrical Engineering, Faculty of Engineering, Universitas Sebelas Maret
, Surakarta, Indonesia
Search for other works by this author on:
Jusuf Abimas Pratama;
Jusuf Abimas Pratama
1
Department of Electrical Engineering, Faculty of Engineering, Universitas Sebelas Maret
, Surakarta, Indonesia
Search for other works by this author on:
Sifa’us Wulaning Arsri;
Sifa’us Wulaning Arsri
1
Department of Electrical Engineering, Faculty of Engineering, Universitas Sebelas Maret
, Surakarta, Indonesia
Search for other works by this author on:
S. Kaleg;
S. Kaleg
2
Research Center of Electronic and Mechatronics, Indonesian Institute of Science (LIPI)
, Bandung, Indonesia
Search for other works by this author on:
A. Hapid;
A. Hapid
2
Research Center of Electronic and Mechatronics, Indonesian Institute of Science (LIPI)
, Bandung, Indonesia
Search for other works by this author on:
Sukmaji. I. Cahyono;
Sukmaji. I. Cahyono
3
Department of Mechanical Engineering, Faculty of Engineering, Universitas Sebelas Maret
, Surakarta, Indonesia
Search for other works by this author on:
Kuncoro Diharjo
Kuncoro Diharjo
3
Department of Mechanical Engineering, Faculty of Engineering, Universitas Sebelas Maret
, Surakarta, Indonesia
Search for other works by this author on:
a)Corresponding author: miftahwar@ft.uns.ac.id
AIP Conf. Proc. 2217, 030063 (2020)
Citation
Ferdiansyah Ashil Farisi, Miftahul Anwar, M. Nizam, Jusuf Abimas Pratama, Sifa’us Wulaning Arsri, S. Kaleg, A. Hapid, Sukmaji. I. Cahyono, Kuncoro Diharjo; Analysis of motor power characterization and power efficiency on operation of electric car prototype. AIP Conf. Proc. 13 April 2020; 2217 (1): 030063. https://doi.org/10.1063/5.0000979
Download citation file:
Sign in
Don't already have an account? Register
Sign In
You could not be signed in. Please check your credentials and make sure you have an active account and try again.
Pay-Per-View Access
$40.00
84
Views
Citing articles via
Design of a 100 MW solar power plant on wetland in Bangladesh
Apu Kowsar, Sumon Chandra Debnath, et al.
Inkjet- and flextrail-printing of silicon polymer-based inks for local passivating contacts
Zohreh Kiaee, Andreas Lösel, et al.
Production and characterization of corncob biochar for agricultural use
Praphatsorn Rattanaphaiboon, Nigran Homdoung, et al.
Related Content
Analytical study of temperature effect on current and voltage of battery at charging and discharging condition on electric vehicle
AIP Conf. Proc. (April 2020)
Light-weight sandwich panel honeycomb core with hybrid carbon-glass fiber composite skin for electric vehicle application
AIP Conference Proceedings (March 2016)
The influence of discharge current to temperature distribution of lithium ion cells
AIP Conf. Proc. (April 2020)
Monitoring system for measurement of lithium battery cell temperature in electric vehicle based on database and website
AIP Conf. Proc. (August 2024)
The failure analysis of bike brake lever: Observation on crack propagation and stress analysis
AIP Conf. Proc. (April 2019)