The present work describes a conceptual study of Staggered Cylinders of Square Cross Section by using Computational Fluid Dynamics. The overall pressure distribution over the cylinders were analyzed. The static pressure distributions on the group of cylinders with square cross sections in a uniform flow velocity of 13.5 m/s at a Reynolds number 4.13 × 104 is presented here. The group consists of three square cylinders of identical dimension. One square cylinder is placed centrally in the upstream side and the other two square cylinders are placed symmetrically in the downstream side. Surface pressure distributions on the cylinders are measured and compared for various longitudinal as well as transverse spacing of the cylinders. Wind loads are obtained in terms of drag coefficients, lift coefficients and total pressure coefficients. The outcome of this investigation was shown and computed by using ANSYS Fluent 16.
Skip Nav Destination
,
,
Article navigation
13 July 2018
INTERNATIONAL CONFERENCE ON MECHANICAL ENGINEERING: Proceedings of the 12th International Conference on Mechanical Engineering (ICME 2017)
20–22 December 2017
Dhaka, Bangladesh
Research Article|
July 13 2018
CFD study of wind effect on staggered cylinders of square cross section with variable longitudinal and transverse spacing
Tanvir Chowdhury;
Tanvir Chowdhury
a)
1
Department of Mechanical Engineering, Military Institute of Science and Technology (MIST)
, Mirpur Cantonment, Dhaka-1216, Bangladesh
a)Corresponding author: [email protected]
Search for other works by this author on:
Md Quamrul Islam;
Md Quamrul Islam
1
Department of Mechanical Engineering, Military Institute of Science and Technology (MIST)
, Mirpur Cantonment, Dhaka-1216, Bangladesh
Search for other works by this author on:
Mohammad Ali
Mohammad Ali
2
Department of Mechanical Engineering, Bangladesh University of Engineering & Technology (BUET)
, Dhaka-1000, Bangladesh
Search for other works by this author on:
Tanvir Chowdhury
1,a)
Md Quamrul Islam
1
Mohammad Ali
2
1
Department of Mechanical Engineering, Military Institute of Science and Technology (MIST)
, Mirpur Cantonment, Dhaka-1216, Bangladesh
2
Department of Mechanical Engineering, Bangladesh University of Engineering & Technology (BUET)
, Dhaka-1000, Bangladesh
a)Corresponding author: [email protected]
AIP Conf. Proc. 1980, 040002 (2018)
Citation
Tanvir Chowdhury, Md Quamrul Islam, Mohammad Ali; CFD study of wind effect on staggered cylinders of square cross section with variable longitudinal and transverse spacing. AIP Conf. Proc. 13 July 2018; 1980 (1): 040002. https://doi.org/10.1063/1.5044312
Download citation file:
Pay-Per-View Access
$40.00
Sign In
You could not be signed in. Please check your credentials and make sure you have an active account and try again.
47
Views
Citing articles via
The implementation of reflective assessment using Gibbs’ reflective cycle in assessing students’ writing skill
Lala Nurlatifah, Pupung Purnawarman, et al.
Classification data mining with Laplacian Smoothing on Naïve Bayes method
Ananda P. Noto, Dewi R. S. Saputro
Effect of coupling agent type on the self-cleaning and anti-reflective behaviour of advance nanocoating for PV panels application
Taha Tareq Mohammed, Hadia Kadhim Judran, et al.
Related Content
An experimental study on the effect of wind load around tall towers of square and hexagonal shapes in staggered form
AIP Conf. Proc. (June 2017)
An experimental investigation of wind flow over tall towers in staggered form
AIP Conf. Proc. (July 2016)
Simulation of wind flow over square, pentagonal and hexagonal cylinders in a staggered form
AIP Conf. Proc. (December 2017)
Analysis of wind pressure coefficients on CTBUH standard high-rise buildings in CFD simulations
AIP Conf. Proc. (July 2019)
Numerical study of the boundary layer flow past two wall mounted finite-length square cylinders in staggered arrangement
Physics of Fluids (January 2022)