Solar thermal collector is a system that converts solar radiation to heat. The heat will raise the temperature higher than the ambient temperature. Absorber and glazing are two important components in order to increase the temperature of the collector. The thermal absorber will release heat by convection and as radiation to the surrounding. These losses will be reduced by glazing. Other than that, glazing is beneficial for protecting the collector from dust and water. This study discusses about modelling of solar thermal collector effects of different mass flow rates with different glazing for V-groove flat plate solar collectors. The glazing used was the glass and linear Fresnel lens. Concentration ratio in this modelling was 1.3 for 0.1m solar collector thickness. Results show that solar collectors with linear Fresnel lens has the highest efficiency value of 71.18% compared to solar collectors with glass which has efficiency 54.10% with same operation conditions.
Skip Nav Destination
,
,
,
Article navigation
4 April 2018
THE 2017 UKM FST POSTGRADUATE COLLOQUIUM: Proceedings of the University Kebangsaan Malaysia, Faculty of Science and Technology 2017 Postgraduate Colloquium
12–13 July 2017
Selangor, Malaysia
Research Article|
April 04 2018
Analytical analysis of solar thermal collector with glass and Fresnel lens glazing Available to Purchase
Idris Zulkifle;
Idris Zulkifle
a)
1
School of Applied Physic, Universiti Kebangsaan Malaysia
43600 UKM Bangi Selangor Malaysia
Search for other works by this author on:
Mohd Hafidz Hj Ruslan;
Mohd Hafidz Hj Ruslan
b)
1
School of Applied Physic, Universiti Kebangsaan Malaysia
43600 UKM Bangi Selangor Malaysia
Search for other works by this author on:
Mohd Yusof Hj Othman;
Mohd Yusof Hj Othman
1
School of Applied Physic, Universiti Kebangsaan Malaysia
43600 UKM Bangi Selangor Malaysia
Search for other works by this author on:
Zahari Ibarahim
Zahari Ibarahim
1
School of Applied Physic, Universiti Kebangsaan Malaysia
43600 UKM Bangi Selangor Malaysia
Search for other works by this author on:
Idris Zulkifle
1,a)
Mohd Hafidz Hj Ruslan
1,b)
Mohd Yusof Hj Othman
1
Zahari Ibarahim
1
1
School of Applied Physic, Universiti Kebangsaan Malaysia
43600 UKM Bangi Selangor Malaysia
AIP Conf. Proc. 1940, 020005 (2018)
Citation
Idris Zulkifle, Mohd Hafidz Hj Ruslan, Mohd Yusof Hj Othman, Zahari Ibarahim; Analytical analysis of solar thermal collector with glass and Fresnel lens glazing. AIP Conf. Proc. 4 April 2018; 1940 (1): 020005. https://doi.org/10.1063/1.5027920
Download citation file:
Pay-Per-View Access
$40.00
Sign In
You could not be signed in. Please check your credentials and make sure you have an active account and try again.
Citing articles via
The implementation of reflective assessment using Gibbs’ reflective cycle in assessing students’ writing skill
Lala Nurlatifah, Pupung Purnawarman, et al.
Effect of coupling agent type on the self-cleaning and anti-reflective behaviour of advance nanocoating for PV panels application
Taha Tareq Mohammed, Hadia Kadhim Judran, et al.
Design of a 100 MW solar power plant on wetland in Bangladesh
Apu Kowsar, Sumon Chandra Debnath, et al.
Related Content
Simulation of double glazed solar collector for the development and application of solar energy
AIP Conf. Proc. (March 2019)
Experimental studies on the thermal efficiency of the single-pass solar air collector with fins
AIP Conf. Proc. (May 2013)
Thermal performance of single glazing V-through solar collector using horizontal and vertical nail cut twisted tape insert
AIP Conf. Proc. (December 2020)
Experimental investigation of a solar cooker based on parabolic dish collector with phase change thermal storage unit in Indian climatic conditions
J. Renewable Sustainable Energy (March 2013)
Thermal efficiency of single-pass solar air collector
AIP Conf. Proc. (November 2013)