Mask Projection micro-Stereolithography (MPμSL) is an additive manufacturing technique capable of producing solid parts with micron-scale resolution from a vat of photocurable liquid polymer resin. Although the physical mechanism remains the same, the process differs from traditional laser-galvanometer based stereolithography (SL) in its use of a dynamic mask UV projector, or digital light processor (DLP), which cures each location within each 3D layer at the same time. One area where MPµSL has garnered considerable attention is in the field of microfluidics and Lab-on-a-Chip, where complex multistep microfabrication techniques adopted from the semiconductor industry are still widely used, and where MPµSL offers the ability to fabricate completely encapsulated fluidic channels in a single step and at low cost [1–3]. However, a significant obstacle exists in the prevention of channel blockage due to overcuring of the polymer resin [4, 5]. Overcuring can be attributed to the so-called ‘back side effect’ [2] which occurs during the build process as light from successive layers penetrates into the resin to a depth greater than the layer thickness. This effect is most prevalent in channels or features oriented horizontally (in a parallel plane to that of the build platform). Currently there are two main approaches in controlling the cure depth; 1. the chemical approach, which involves doping the resin material with a chemical light absorber [6–8]; and 2. by improving the system's hardware and optical elements to improve the homogeneity of the light dosage and control the cure depth [9]. Here we investigate a third approach through modification of the 3D CAD file prior to printing to mitigate for UV light leakage from successive build layers. Although used here in conjunction with the MPμSL technique, this approach can be applied to a range of SL techniques to improve printer resolution and enable production of internal features with higher dimensional accuracy.
Skip Nav Destination
Article navigation
16 October 2017
PROCEEDINGS OF THE 20TH INTERNATIONAL ESAFORM CONFERENCE ON MATERIAL FORMING: ESAFORM 2017
26–28 April 2017
Dublin, Ireland
Research Article|
October 16 2017
Mitigation and control of the overcuring effect in mask projection micro-stereolithography
Paul F. O'Neill;
Paul F. O'Neill
a)
1
Advanced Processing Technology Research Centre, Dublin City University
, Ireland
Search for other works by this author on:
Nigel Kent;
Nigel Kent
1
Advanced Processing Technology Research Centre, Dublin City University
, Ireland
2
School of Mechanical and Design Engineering, Dublin Institute of Technology
, Ireland
Search for other works by this author on:
Dermot Brabazon
Dermot Brabazon
1
Advanced Processing Technology Research Centre, Dublin City University
, Ireland
Search for other works by this author on:
a)
Corresponding author: paul.oneill37@mail.dcu.ie
AIP Conf. Proc. 1896, 200012 (2017)
Citation
Paul F. O'Neill, Nigel Kent, Dermot Brabazon; Mitigation and control of the overcuring effect in mask projection micro-stereolithography. AIP Conf. Proc. 16 October 2017; 1896 (1): 200012. https://doi.org/10.1063/1.5008249
Download citation file:
Sign in
Don't already have an account? Register
Sign In
You could not be signed in. Please check your credentials and make sure you have an active account and try again.
Pay-Per-View Access
$40.00
Citing articles via
The effect of a balanced diet on improving the quality of life in malignant neoplasms
Yu. N. Melikova, A. S. Kuryndina, et al.
Animal intrusion detection system using Mask RCNN
C. Vijayakumaran, Dakshata, et al.
Recognition of cat ras of face and body using convolutional neural networks
Akhmad Wahyu Aji, Esmeralda Contessa Djamal, et al.
Related Content
Surface roughness control by extreme ultraviolet (EUV) radiation
AIP Conference Proceedings (October 2017)